Single ramming pile

CG201 Single ramming pile solution

ADVANTAGES OF PUNCHING PILE
 
Simple and fast installation Instead of preparing cement base in advance the vertical shaft is punched into the ground (pile driving depth: 1500-2000mm) by a pile driver which greatly saves the installation time and cost.  
 
Strong adaptability to installation site Punching pile has lower requests for surface flatness than traditional cement foundation and its installation is not affected by the seasons.
 
Environmental friendly Without performing and preparation works the surrounding areas remain unspoiled. Besides without corruption and zero disposal costs the pile is totally recyclable complying with the environmental protection concept.  
 
Easy and quick relocation Punching pile is easy to remove so that the installation site can be reused. 
 
In this solution the back support is the punching pile which is about 3m long. We also have independent punching piles such as punching pile with flange plate and punching pile without flange plate. For more information about them pls look at the document named Double Punching Pile Solution. 
 
Pile

Pile

Side support

Side support

Back support

Back support

Oblique beam

Oblique beam

Beam connector

Beam connector

Beam connector

Middle clamp

Middle clamp

End clamp

End clamp

Screw

Screw

Screw


Installation Site: Open field
 
Tilt Angle: According to customer’s feasibility study
 
Applicable Module: Silicon / thin-film module
 
Material: Q235B & Al6063 T5
 
Surface Treatment: Hot-dip galvanizing & anodizing
 
Wind Load: 130km / h
 
Snow Load: 0.5kN / m²
 

If you are interested in our products
please feel free to send an e-mail to info@cmsolarcn.com
Or call us: +86 512 83561606

RFQ-CHECK LIST FOR GROUND MOUNTING SOLUTION

Thank you for selecting CM Solar. Please complete this form and send it by Mail to info@cmsolarcn.com

PROJECT INFORMATION
Your name is required.
Project is required.
Altitude is required.
Location is required.
Street/No. is required.
Postcode/City is required.
Country is required.
Tel.NO. is required.
Topographic situation
Panels Features
Panel is required.
Weight is required.
kg
Nominal output is required.
Wp
Overall performance is required.
MW
Dimensions is required.
mm
Total number is required.
pcs
DESIGN CONDITION
Design code is required.
Wind Speed is required.
m/s
Structure pitch is required.
°
Snow load is required.
kn/m²
Module layout is required.
Minimum Ground Clearance is required.
mm
CORROSION

Atmospheric Corrosion Category(ISO9223):

FOUNDATION SELECTION
Embedment Depth is required.

mm

(a)
(b)
(c)
(c)
OTHER INFORMATION